Upgrade your street-legal BMW's braking power with Hawk Performance's HPS front brake pads. These high-performance street disc brake pads are renowned for significantly boosting stopping power. By choosing the Hawk HPS braking compound, you can easily enhance your vehicle's braking system. The High Performance Street compound offers a higher friction coefficient than stock brake pads, delivering 20 - 40% more stopping power and greater resistance to brake fade compared to most standard replacement pads. With less fade, you'll enjoy a better pedal feel and more consistent performance, along with less brake dust. These pads fit a wide range of 2013 - 2019 BMW models, including the 228i, 230i, 320i, 328d, 328i, 330e, 330i, 428i, 430i, X3, and X4 in various trims.
Using these brake pads is straightforward. First, make sure your vehicle is parked on a flat surface and the engine is off. Remove the old brake pads and carefully install the new Hawk HP Plus brake pads following the vehicle's service manual. When driving with the new pads, start with gentle braking for the first few miles to allow them to bed in properly. This helps ensure optimal performance and longevity. As for maintenance, regularly check the brake pads for wear. If you notice excessive wear or a change in braking performance, it's time to replace them. Also, keep the brake calipers clean to prevent any debris from affecting the brake pads' performance. Avoid harsh braking right after installation and in extreme weather conditions as much as possible to extend the life of the brake pads.
