The factory intake tract on the 2022 - 2024 Honda Civic and 2023 - 2024 Acura Integra restricts power by choking the turbo. The Injen SP1586 cold air intake revolutionizes this with a huge 3.00 - inch aluminum intake tube. It uses Injen's patented MegaRam Technology, allowing precise fuel - trim tuning and maximum power output. After the MR step - down, the system briefly expands to 2.50 inches before the turbo inlet, maintaining airspeed for better throttle response. Unlike many short - ram and enclosed systems, this cold air intake boosts power across the entire RPM range, not just at the top - end. This part fits multiple models and sub - models from 2022 - 2024 Honda Civic and 2023 - 2024 Acura Integra, including EX, EX - L, Si, A - Spec, and Base.
Using this Injen cold air intake is easy. First, make sure your vehicle's engine is off and cool. Remove the factory intake system and install the Injen SP1586 in its place following the included instructions. When it comes to maintenance, check the air filter regularly. If it looks dirty, clean or replace it as needed. This will keep the intake working efficiently. Also, be careful not to over - tighten the bolts during installation to avoid damaging the parts. During extreme weather conditions, especially heavy rain or snow, it's a good idea to check the intake for any water or debris that might have gotten in. With proper use and maintenance, this cold air intake will enhance your vehicle's performance for a long time.
