Boost your engine's performance with this K&N intake kit. The high - density polyethylene (HDPE) rotationally - molded tube significantly increases airflow volume to your engine, guaranteeing a notable rise in horsepower and torque. Paired with a washable, reusable High - Flow Air Filter made of oiled cotton media, its oversized, conical design allows up to 100,000 miles between filter services under normal highway driving. A custom heat shield protects intake air from the high engine bay temperatures. Installation is a breeze, typically taking less than 60 minutes. Note that some intakes are not legal for sale or use on pollution - controlled motor vehicles in California. Check the product specifications for CARB status for your specific vehicle. This part fits multiple 1993 - 1998 Jeep Grand Cherokee submodels including Base, Laredo, Limited, Orvis, SE, and TSi.
Using this K&N intake kit is simple. First, make sure your engine is cool. Remove the old intake system and then install the new kit following the step - by - step instructions. It usually takes less than an hour. During normal highway driving, you can go up to 100,000 miles before you need to service the air filter. When it's time, take out the filter, wash it with a special filter cleaner, let it dry, and then re - oil it. The heat shield is there to protect the intake air, so don't remove it. Also, be aware that in California, some versions of this intake may not be legal for use on pollution - controlled vehicles. Always check the CARB status for your vehicle before installing.
