Upgrade your 1996 - 1997 Ford Bronco or F - Series truck with the K&N AirCharger 63 - 1014 air intake system. It replaces the restrictive factory air filter and intake housing, allowing your engine to breathe easier. By smoothing and straightening airflow, it significantly reduces intake restriction. This means your engine can take in more air, delivering more usable power and better acceleration across the RPM range. The intake comes with a chrome - topped K&N high - flow air filter clamped to the hoses, guaranteeing a power boost. The large air filter can last up to 100,000 miles before servicing, depending on driving conditions. Installation is a breeze with common tools. Note that this air intake cannot be sold or used in California and other states following California emission standards. Here are the compatible models: 1996 Ford Bronco (Eddie Bauer, XL, XLT, XLT Sport); 1996 Ford F - 150 (Eddie Bauer, Special, XL, XLT); 1996 - 1997 Ford F - 250 (Base, Eddie Bauer, Lariat, Special, XL, XLT), 1997 Ford F - 250 HD (XL, XLT); 1996 - 1997 Ford F - 350 (Base, Special, XL, XLT).
Using the K&N AirCharger 63 - 1014 air intake system is easy. First, gather common tools for installation. Follow the step - by - step instructions provided with the intake to remove the factory air filter and housing and install the new intake. Once installed, your vehicle should immediately experience improved power and acceleration. As for maintenance, the oversized air filter can go up to 100,000 miles before servicing, but it's a good idea to check it regularly, especially if you drive in dusty or dirty conditions. If the filter looks dirty, clean it according to the K&N cleaning instructions. Remember, this air intake is not legal for use in California or states with California emission standards, so make sure your vehicle complies with local regulations before using it.
