K-Tuned Thermal Gasket Throttle Body

Boost your engine's power with K-Tuned Intake Manifold and Throttle Body Heatshield Gaskets. Crafted from high-grade temperature-insulating plastic, these precision-cut gaskets replace OEM ones. By insulating the intake and throttle body from engine heat, they lower intake air temperature and increase horsepower. When your engine runs, the cylinder head gets very hot. These gaskets break the heat transfer between the cylinder head and the intake manifold and throttle body, creating cooler incoming air. As air heats up, its density drops, reducing oxygen and power as your ECU compensates with less fuel. On average, you lose about 1% of density for every 5 degrees Fahrenheit increase in temperature. Say goodbye to heat soak with these gaskets installed on your motor. Applications: See applications listed beside the part numbers below. K-Tuned Throttlebody Heatshield Gaskets: KTG-PRB-TB - RSX Throttle Body; KTG-RBC-TB - RBC (06 - 11 Civic Si) Throttle Body; KTG-TSX-0405 - TSX (04 - 05) and RRC Throttle Body; KTG-RBC-J35 - RBC/RRC intake manifold with J35 Throttle Body (Covers IACV Hole); KTG-ZDX-TB - ZDX Throttle Body (Black).

Using these K-Tuned gaskets is easy. First, locate the OEM gaskets on your intake manifold and throttle body. Carefully remove the old gaskets and clean the surfaces thoroughly. Then, place the new K-Tuned gaskets in the same position as the old ones. Make sure they fit snugly. When installing, be gentle to avoid damaging the gaskets. As for maintenance, there's not much you need to do. Just keep an eye on them during regular engine check-ups. If you notice any signs of wear or damage, replace them right away. Also, always follow your vehicle's normal maintenance schedule. That way, these gaskets will keep working well and helping your engine perform at its best.